Air Filters

A kit specifically for cleaniing and re-oiling K&N air filter elements.

This is an S&B American made, chrome finished conical filter. It will clamp straight on the back of the original Mikcarb once the original air filter has been removed. It will enhance the performance and is washable.

Note 1: This can be fitted to the Electra (X), but the R/H cover will need to be modified a little.

Note 2: We have a range of sizes available to fit other carburettors.

This chrome finished S&B filter is the "pancake" version of the filter above above. It will enhance the performance and is washable, and again will fit the Mikcarb.

Note 1: We have a range of sizes available to fit other carburettors.

Genuine K&N air filter element to replace the standard round ones found on most 1998 onwards models. Gives enhanced performance and is washable.

Early models (metal gauze on inside).

Early models (metal gauze on outside).

Early models (metal gauze on outside & foam).

1998 on models (fits inside triangular box).

This is an English made polished alloy bell mouth with gauze. A typical 60's accessory. It is supplied complete with clip to fix straight on the Mikcarb.

This is the early style air filter assembly and allows you to remove the original filter that is fitted in the right hand toolbox on late models, thus freeing up this toolbox for other purposes (it is not possible to modify your existing rectangular box due to the different way in which it draws air). This assembly comes complete with element and transfer and is powder coated in black or chromed.

Both these products are Indian made.

This is a great looking, stainless steel cover that fits over the top of the conical shaped S&B filter. It will help prevent water dripping on to the filter when left in the rain and looks great. It will fit with the Mikarb or Amal carburettors

This is a stainless steel cover to hide the majority of the fuel injection system and wires etc.

When fitting a performance air filter it can leave your coil and wires on view. This is a specially designed fibreglass cover to shield these. Finished in black it blends in with the bike and goes un-noticed.
There are 2 types available. Please order 92016 if you have the two large diameter air filter holes in the rear of the triangular box and order 92015 for all others. Please note these will require the drilling of one 8mm hole in the rear of the triangular box.

An English made product replaces the standard rubber between the carburettor and the rectangular box. Suitable for all Indian made models fitted with a Mikarb.

This genuine Mikuni intake manifold replaces the version that was fitted to the 500 Bullets between 1989 and 1996. It is less prone to perishing than the original.

Note: This will not fit Bullets manufactured after 1996.

This hose replaces the inlet hose, part 143143, that was fitted on 1997 and later 500cc Bullets. It is less prone to perishing than the original.